Anti-Lock Control - Traction Control
WARNING: This page is about a different car, the 2003 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Use of any other than approved DOT 3 brake fluid will cause permanent damage to brake components and will render the brakes inoperative.
WARNING:
Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately.
CAUTION:
Brake fluid is harmful to painted or plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
Use clean, fresh Ford High Performance DOT 3 Motor Vehicle Brake Fluid C6AZ-19542-AB or equivalent meeting Ford specification ESA-M6C25A.
- Do not reuse brake fluid drained or bled from the system.
- Do not use brake fluid that has been stored in an open container.
- Do not use contaminated brake fluid.
The anti-lock brake system consists of the following components:
- Anti-lock brake sensors (2C204, 2C190)
- Anti-lock brake sensor indicator.
- Anti-lock brake control module (2B373).
- Anti-lock brake hydraulic control unit (2C346).