Removal and Installation

WARNING: This page is about a different car, the 2003 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Prior to removal of the FEM, it is necessary to upload module configuration information to a diagnostic tool. This information needs to be downloaded into the new module once installed. For additional information, refer to MODULE CONFIGURATION .

Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
Remove the instrument panel lower steering column opening cover.
1. Remove the bolts.
Fig 1: Removing Instrument Panel Lower Steering Column Opening Cover
Courtesy of FORD MOTOR CO.
Remove the instrument panel opening cover reinforcement.
1. Remove the bolts.
  
  Fig 2: Removing Instrument Panel Opening Cover Reinforcement
  Courtesy of FORD MOTOR CO.
Remove the front electronic module (FEM).
1. Disconnect the five electrical connectors.
2. Remove the three bolts.
  
  Fig 3: Removing Front Electronic Module (FEM)
  Courtesy of FORD MOTOR CO.

CAUTION: Once the new module is installed, it is necessary to download the module configuration information from the diagnostic tool into the new module. For additional information, refer to MODULE CONFIGURATION .

To install, reverse the removal procedure.