LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2003 >> ZX2 Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transaxle/Transmission External Controls) >> General Procedures >> Bezel Adjustment - Transmission Control Selector Dial
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Bezel Adjustment - Transmission Control Selector Dial

WARNING: This page is about a different variant/trim than selected.
  1. Place the gearshift lever in the PARK position.
  2. Loosen the transmission control selector dial bezel screws.
    Fig 1: Loosening Transmission Control Selector Dial Bezel Screws
    G01372220Courtesy of FORD MOTOR CO.
  3. Place a (A) stiff wire in the (B) slider panel and position the pointer on the (B) slider panel to align with the PARK position on the (C) transmission control selector dial bezel (7D443).
    Fig 2: Aligning Shift Indicator
    G01372221Courtesy of FORD MOTOR CO.
  4. Tighten the transmission control selector dial bezel screws in the sequence shown.
Fig 3: Tightening Transmission Control Selector Dial Bezel Screws
G01372222Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals