LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2004 >> Excursion 5.4 L, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1014 (MULTIFUNCTION Electronic Modules System) >> Removal And Installation >> Air Suspension Module >> Removal and Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Prior to removal of the module, it is necessary to upload the module configuration information to a diagnostic tool. This information needs to be downloaded into the new module once installed. For additional information, refer to MODULE CONFIGURATION .
  1. Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the 2 pin-type retainers from the instrument panel lower insulator and position the insulator aside.
  3. Disconnect the power point electrical connector and the footwell lamp and remove the panel.
  4. Disconnect the air suspension module electrical connectors.
  5. Release the spring clips to remove the module from the bracket.
    6. CAUTION: Once the new module is installed, it is necessary to download the module configuration information from the diagnostic tool into the new module. For additional information, refer to MODULE CONFIGURATION .
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals