Intake Air System, Fuel Charging System & Engine Electronics System-4.0L SOHV Engine

• Specifications
  • General Specifications
  • Torque Specifications
• Description And Operation
  • Intake Air
  • Fuel Charging and Controls
  • Engine Ignition
  • Starting System
  • Electronic Engine Controls
• Diagnosis And Testing
  • Intake Air Distribution and Filtering
  • Fuel Charging and Controls
  • Starting System
    • Notes
    • Special Tool(s)
    • Inspection and Verification
    • Symptom Chart
    • Connector Reference and Terminal Readings
      • Ignition Switch - C250
      • Starter Relay - C1017
      • Passive Anti-Theft (PATS) - C2007
      • Digital Transmission Range (DTR) Sensor - C167
    • Pinpoint Tests
      • Normal Operation
      • Possible Causes
      • Pinpoint Test A: The Engine Does Not Crank Or Relay Clicks
      • Pinpoint Test B: Unusual Starter Noise
    • Component Tests
      • Starter Motor - Voltage Drop Test
      • Starter Motor - Motor Feed Circuit
      • Starter Motor - Motor Ground Circuit
  • Engine Ignition
  • Electronic Engine Controls
• Removal And Installation
  • Air Cleaner Assembly
    • Removal and Installation
  • Throttle Body
    • Removal and Installation
  • Fuel Injection Supply Manifold and Fuel Injector
    • Special Tool(s)
    • Material
    • Removal and Installation
    • Item 1: Fuel Tube Spring Lock Coupling Removal Note
    • Item 1: Fuel Tube Spring Lock Coupling Installation Note
  • Fuel Pulse Damper
    • Material
    • Removal and Installation
    • Item 4: Fuel Pulse Damper O-Ring Installation Note
  • Fuel Pressure and Temperature Sensor
    • Material
    • Removal and Installation
    • Item 5: Fuel Pressure and Temperature Sensor O-ring Installation Note
  • Ignition Coil, Spark Plug Wires and Spark Plug
    • Special Tool(s)
    • Material
    • Removal and Installation
    • Item 3: Spark Plug Wire-to-Ignition Coil Removal Note
    • Item 5: Spark Plug Wire-to-Spark Plug Removal Note
    • Item 5: Spark Plug Wire-to-Spark Plug Installation Note
  • Starter Motor
    • Removal and Installation
  • Camshaft Position (CMP) Sensor
    • Removal and Installation
  • Crankshaft Position (CKP) Sensor
    • Removal and Installation
  • Powertrain Control Module (PCM)
    • Removal and Installation
    • Item 3: A-Pillar Lower Trim Panel Removal Note
    • Item 7: PCM and Mounting Bracket Removal Note
    • Item 7: PCM and Mounting Bracket Installation Note
  • Engine Coolant Temperature (ECT) Sensor
    • Removal and Installation
  • Mass Air Flow (MAF) Sensor
    • Removal and Installation
  • Heated Oxygen Sensor (HO2S) and Catalyst Monitor Sensor
    • Special Tool(s)
    • Material
    • Removal and Installation
    • Item 2: Catalyst Monitor Removal Note
    • Item 3: Heated Oxygen Sensor Removal Note
    • Item 3: Heated Oxygen Sensor Installation Note
    • Item 2: Catalyst Monitor Installation Note
  • Knock Sensor (KS)
    • Removal and Installation