Inspection And Verification

1. Verify the customer concern.
2. Visually inspect obvious signs of mechanical or electrical damage.
   VISUAL INSPECTION CHART
   
   

   Electrical
   Fuse(s) Wiring harness Loose or corroded connector(s) Damaged connector(s)

3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
4. If the cause is not visually evident, connect the diagnostic tool to the data link connector and select the vehicle to be tested from the diagnostic tool menu. If the diagnostic tool does not communicate with the vehicle:
   • check that the program card is correctly installed.
   • check the connections to the vehicle.
   • check the ignition switch position.

If the diagnostic tool still does not communicate with the vehicle, Go To PINPOINT TEST J: NO MODULE/NETWORK COMMUNICATION  .

Go To PINPOINT TEST PC: RUN THE DATA LINK DIAGNOSTICS TEST  .