Speed Control Deactivator Switch: Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: The initial installation of a speed control deactivator switch allows for adjustment. If additional adjustments are required, install a new switch.

Release the plunger lock.
- Turn the lock knob counterclockwise until the first click is felt.
  
  Fig 1: Releasing Plunger Lock
  Courtesy of FORD MOTOR CO.
Press and hold the brake pedal.
Install the speed control deactivator switch.
- Position the speed control deactivator switch in the bracket and rotate clockwise 45 degrees.
- Connect the electrical connector.

NOTE: There should be an extra click heard when tugging on the brake pedal.

Slowly release the brake pedal and tug moderately once the pedal reaches the rest position.