Section 1933 (Vehicle Dynamic Systems)
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Description And Operation
- Diagnostic Tests
- Anti-Lock Control
- Notes
- Principles of Operation
- Inspection and Verification
- Inspection and Verification - Drive Cycle Test
- Symptom Chart
- Pinpoint Tests
- Notes
- Pinpoint Test A: DTCs B1317 and B1318 - Battery Voltage High/Low
- Pinpoint Test B: DTCs C1095 and C1096 - ABS Hydraulic Pump Motor Circuit Failure/Open
- Pinpoint Test C: Vehicle Pulls During Braking or ABS False Activation/Too Sensitive/Activates On a Normal Stop
- Pinpoint Test D: ABS False Activation, ABS Too Sensitive, ABS Activates On a Normal Stop
- Pinpoint Test E: DTC C1222 - Wheel Speed Mismatch
- Pinpoint Test F: DTC C1446 - Brake Fluid Level Low/Brake Switch Circuit Failure
- Anti-Lock Control - Traction Control and Stability Assist
- Notes
- Principles of Operation
- Inspection and Verification
- Symptom Chart
- Pinpoint Tests
- Notes
- Pinpoint Test G: DTCs B1317 and B1318 - Battery Voltage High/Low
- Pinpoint Test H: DTCs C1095 and C1096 - ABS Hydraulic Pump Motor Circuit Failure/Open
- Pinpoint Test I: ABS False Activation, ABS too Sensitive, ABS Activates On a Normal Stop
- Pinpoint Test J: Vehicle Pulls During Braking or ABS False Activation/too Sensitive/Activates On a Normal Stop
- Pinpoint Test K: DTCs B1104, C1277 and C1278 - Steering Wheel Angle Sensor Fault and DTC C1963 - Stability Control Inhibit Warning
- Pinpoint Test L: DTCs C1279, C1280, C1281, C1282, C1516, C1517, C1963, C2769, C2770 and U0028 - Sensor Cluster Fault and Vehicle Communication Bus Off
- Pinpoint Test M: DTC C1288 - Pressure Transducer Main/Primary Input Circuit Failure
- Pinpoint Test N: DTC C1446 - Base Brake Failure/Brake Switch Stuck or Inoperative
- Pinpoint Test O: DTC C1991 - Module Calibration Failure
- Pinpoint Test P: The Traction Control System Cannot Be Disabled/Enabled or the Traction Control System is Inoperative
- Pinpoint Test Q: The Traction Control OFF Indicator (in the Switch) is Always/Never On
- Anti-Lock Control
- Removal And Installation