Removal and Installation
- Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
- Remove the wiper mounting arm and pivot shaft assembly. For additional information, refer to WIPERS AND WASHERS .
- Remove the intake manifold runner (IMRC) control valve.
- Disconnect the IMRC valve electrical connector.
- Remove the IMRC valve retainer screws and the IMRC valve.
- Disconnect the powertrain control module (PCM) electrical connector and remove the gasket.
- Disconnect the vacuum hose from the exhaust gas recirculation (EGR) valve.
- Remove the EGR vacuum regulator solenoid inboard fastener.
- Loosen the outboard EGR vacuum regulator solenoid retaining screw and rotate the unit out of the way to allow clearance for PCM removal.
- Remove the retaining bolts and the PCM.
- To install, reverse the removal procedure.
ALL VEHICLES
VEHICLES WITH 3.0L 2V ENGINE
ALL VEHICLES
VEHICLES WITH 3.0L 2V ENGINE
ALL VEHICLES