Adjustable Pedals With Memory Feature
- Verify the customer concern by operating the adjustable pedals.NOTE: If the adjustable pedals are not installed on the vehicle, when a self-test is performed the module will set pedal codes.
- Visually inspect for obvious signs of mechanical or electrical damage.VISUAL INSPECTION CHART
Mechanical Electrical - Adjustable pedals
- Damaged or corroded connector
- Adjustable pedal switch
- Damaged or corroded wiring harness
- Central junction box (CJB) fuse(s):
- (15A).
- (5A).
- 112 (30A)
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
- If the diagnostic tool does not power up, refer to the diagnostic tool manual.
- Carry out the diagnostic tool data link test. If the diagnostic tool responds with:
- SCP, UBP, CAN, or ISO circuit fault; all electronic control units no response/not equipped, REFER to MODULE COMMUNICATIONS NETWORK .
- No response/not equipped for driver seat module (DSM), REFER to MULTIFUNCTION ELECTRONIC MODULES .
- System passed, retrieve and record the continuous DTCs and carry out self-test diagnostics for the DSM.
- If the DTCs retrieved are related to the concern, go to the DRIVER SEAT MODULE (DSM) DIAGNOSTIC TROUBLE CODE (DTC) INDEX .
- If no DTCs related to the concern are retrieved, GO to SYMPTOM CHART - ADJUSTABLE PEDAL WITHOUT MEMORY or GO to SYMPTOM CHART - ADJUSTABLE PEDAL WITH MEMORY to continue diagnosis.