Engine Controls - Rattle From PCM/ECM Bracket
TSB 05-12-206/27/05
RATTLE - PCM BRACKET
FORD:
2005 Focus
ISSUE
Some 2005 Focus vehicles built prior to 5/2/2005, may exhibit a rattle from the powertrain control module (PCM)-to-PCM bracket interface.
ACTION
Apply urethane foam tape as an insulator between PCM and PCM bracket.
SERVICE PROCEDURE
1. Remove the PCM and GEM. Refer to Workshop Manual Section 303-14.
NOTE
DO NOT REMOVE THE PCM BRACKET.
2. Obtain a piece of urethane foam tape (164-R4902), approximate size 5/8 x 1-1/4" (16 x 32 mm) from the Rotunda Squeak and Rattle Repair Kit (164-R4900).
3. Apply the tape to the upper corner of PCM bracket (Figure 1).
4. Reinstall PCM and GEM.
Parts Block
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
OPERATION DESCRIPTION TIME
051202A 2005 Focus Apply 0.6 Hr.
Urethane Foam Tape
Between The PCM And
PCM Bracket (Do Not Use
With 12650D6)
DEALER CODING
CONDITION
BASIC PART NO. CODE
12A692 42
Disclaimer