LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2005 >> Freestar Base >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Anti-Theft System - Pats >> General Procedures >> Key Programming Using Two Programmed Keys >> Programming Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Programming Procedure

  1. Insert a programmed ignition key into the ignition lock cylinder and turn the ignition switch from the OFF position to the RUN position (maintain the ignition switch in the RUN position for 3 seconds, but not longer than 10 seconds).
  2. Turn the ignition switch to the OFF position and remove the first key from the ignition lock cylinder.
  3. Within 10 seconds of turning the ignition switch to the OFF position, insert a second programmed ignition key into the ignition lock cylinder and turn the ignition switch from the OFF position to the RUN position (maintain the ignition switch in the RUN position for 3 seconds, but not longer than 10 seconds).
  4. Turn the ignition switch to the OFF position and remove the second key from the ignition lock cylinder.
  5. Within 20 seconds of turning the ignition switch to the OFF position, insert the unprogrammed ignition key (new key) into the ignition lock cylinder and turn the ignition switch from the OFF position to the RUN position (attempt to start the vehicle).
  6. If additional programmed key(s) are desired, repeat the key programming procedure.
scientia non olet · About LEMON Manuals