Fan Control
The PCM monitors certain parameters (such as engine coolant temperature, vehicle speed, A/C on/off status, A/C pressure) to determine engine cooling fan needs.
For variable speed electric fan(s):
The PCM controls the fan speed and operation using a duty cycle output on the fan control - variable (FCV) circuit. The fan controller (located at or integral to the engine cooling fan assembly) receives the FCV command and operates the cooling fan at the speed requested (by varying the power applied to the fan motor).
| FCV Duty Cycle Command (NEGATIVE (-) duty cycle) | Cooling Fan Response/Speed |
|---|---|
| Greater than 0 but less than 5% | Fan off, controller inactive |
| Greater than 5% but less than 10% | Fan off, controller is in active/ready state |
| Crown Victoria/Grand Marquis, Town Car: 10% - 90% | Crown Victoria/Grand Marquis, Town Car: Linear speed increase from 20% to 100% |
| Five Hundred/Freestyle/Montego: 30% - 90% | Five Hundred/Freestyle/Montego: Linear speed increase from 50% to 100% |
| Greater than 90% but less than 95% | 100% |
| Greater than 95% but less than 100% | Fan off |
| FCV Duty Cycle Command (positive (+) duty cycle) | Cooling Fan Response/Speed |
|---|---|
| Greater than 0 but less than 4% | 100% (default maximum) |
| Greater than 4% but less than 6% | 100% if duty cycle is increasing 0% (off) if duty cycle is decreasing |
| Greater than 6% but less than 12% | 0% (off) |
| Greater than 12% but less than 16% | 20% if duty cycle is increasing 0% if duty cycle is decreasing |
| 16% - 90% | Linear speed increase from 20% to 100% |
| Greater than 90% but less than 100% | 100% (default maximum) |
For relay controlled fans:
The PCM controls the fan operation through the fan control (FC) (single speed fan applications), low fan control (LFC), medium fan control (MFC), and/or high fan control (HFC) outputs. Some applications will have the xFC circuit wired to 2 separate relays.
For 3-speed fans, although the PCM output circuits are called low, medium, and high fan control (FC), cooling fan speed is controlled by a combination of these outputs. Refer to the following table.
| PCM OUTPUT | LOW SPEED | MEDIUM SPEED | HIGH SPEED | FAN OFF |
|---|---|---|---|---|
| LFC (FC1) | ON | ON | ON | OFF |
| MFC (FC2) | ON | OFF | ON | OFF |
| HFC (FC3) | ON | OFF | OFF | OFF |
| PCM OUTPUT | LOW SPEED | MEDIUM SPEED | HIGH SPEED | FAN OFF |
|---|---|---|---|---|
| LFC (FC1) | ON | ON | ON | OFF |
| MFC (FC2) | OFF | ON | OFF (or ON) | OFF |
| HFC (FC3) | OFF | OFF | ON | OFF |
| PCM OUTPUT | LOW SPEED | MEDIUM SPEED | HIGH SPEED | FAN OFF |
|---|---|---|---|---|
| LFC (FC1) | OFF | ON | ON | OFF |
| MFC (FC2) | ON | OFF | ON | OFF |
| HFC (FC3) | ON | ON | ON | OFF |