Removal and Installation
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
- Disconnect the exhaust gas recirculation (EGR) system module-to-exhaust manifold tube upper nut.
- To install, tighten to 40 Nm (30 lb-ft).
- Disconnect the EGR system module-to-exhaust manifold tube lower nut and remove the EGR system module-to-exhaust manifold tube.
- To install, tighten to 40 Nm (30 lb-ft).
- Disconnect the EGR system module electrical connector.
- Disconnect the EGR system module vacuum connector.
- Remove the 2 bolts and the EGR system module.
- Remove and discard the EGR system module gasket.
- Carefully clean the EGR system module gasket sealing surfaces.
- To install, tighten to 25 Nm (18 lb-ft).
- To install, reverse the removal procedure.
- Install a new EGR system module gasket with the side with the raised circle facing the intake manifold.
NOTE:
The EGR system module gasket sealing surfaces are soft metals.
NOTE:
Do not reuse the EGR system module gasket.