Removal and Installation
- Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
- Remove the wiper motor and pivot assembly. For additional information, refer to WIPERS AND WASHERS .
- Disconnect the electrical connector from the ignition coil.
- Disconnect the 6 spark plug wires from the ignition coil.
- Remove the 3 bolts and the ignition coil.
- To install, tighten to 7 Nm (62 lb-in).
- To install, reverse the removal procedure.
CAUTION:
It is important to twist the spark plug wire boots while pulling upward to avoid possible damage to the spark plug wires.
CAUTION:
Spark plug wires must be connected to the correct ignition coil terminal. Mark the spark plug wire locations before removing them.