Removal and Installation
- Remove the upper intake manifold. For additional information, refer to ENGINE .
- Disconnect the ignition coil electrical connectors.
- Remove the ignition coil bolts.
- To install, tighten to 6 Nm (53 lb-in).
- Remove the ignition coils.
- To install, reverse the removal procedure.
- Apply a light film of Silicone Brake Caliper Grease and Dielectric Compound XG-3-A meeting Ford specifications ESE-M1C171-A to the inside of the coil boots before installation.
RH ignition coils
All ignition coils
NOTE:
When removing the ignition coils, a slight twisting motion will break the seal and ease removal.