Safety Belt With Anchor Plate Thread Damage
- Remove the broken or stripped bolt.
- Drill out the internal threads in the safety belt anchor plate with a 27/64-inch drill bit.
- Rethread the anchor plate with a 1/2-13-tap.
- Blow out the chips.
- Install the attachment parts in the correct sequence. Install a new bolt, hand-tighten and then tighten to correct torque specifications as noted in the TORQUE SPECIFICATIONS .
NOTE:
The following is for 7/16-20 bolts only.
NOTE:
The lap/shoulder safety belts are factory-installed in their correct locations. If the safety belts are removed for any reason, they must be installed. The anchor bolts must be hand-started and then tightened to the correct torque specifications as noted in the Torque Specifications table.
NOTE:
New parts are to be used in place of the original parts.