LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2006 >> Focus ZX4 ST >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Fuel Charging System & Engine Controls >> Removal And Installation >> Fuel Pump Driver Module (FPDM)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel Pump Driver Module (FPDM)

Fig 1: Identifying Fuel Pump Driver Module (FPDM) Components
G04652510Courtesy of FORD MOTOR CO.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY MOUNTING AND CABLES .
  2. Pull up the rear seat.
  3. Position the floor covering to one side.
  4. Disconnect the fuel pump driver module (FPDM) electrical connector.
  5. Remove the 2 nuts and the FPDM.
    • To install, tighten to 5 Nm (44 lb-in).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals