Selector Lever Cable Adjuster

Fig 1: Identifying Selector Lever Cable Adjuster - Closed Position

Courtesy of FORD MOTOR CO.

Adjuster in CLOSED position; lift in the direction of the arrow to open.

Fig 2: Identifying Selector Lever Cable Adjuster - Open Position

Courtesy of FORD MOTOR CO.

Adjuster in OPEN position; press in the direction of the arrow to close.

• A quick-release fastener on the selector lever cable allows adjustment of the cable relative to the conduit.
• Adjustment is required if the transaxle or the selector lever has been removed, if the engine does not start in PARK or NEUTRAL in case of shift quality concerns or if the switch catches are incorrect.
  Fig 3: Identifying Transaxle Selector Lever - DRIVE Position

  Courtesy of FORD MOTOR CO.

  To adjust the selector lever cable, the selector lever must be in DRIVE position.

  Fig 4: Selector Lever Cable Adjuster - Open Position

  Courtesy of FORD MOTOR CO.

First open the selector lever cable adjuster.

• To make sure the transaxle is in DRIVE position the cable should be removed from the shift shaft lever, the transaxle should be shifted in DRIVE and the selector lever cable should be clipped again onto the shift shaft lever.
• The selector lever cable must not be stressed. The selector lever cable must be free from binding.
  Fig 5: Locking Selector Lever Cable Adjuster - Closed Position

  Courtesy of FORD MOTOR CO.

The selector lever cable is locked by pressing the cable adjuster after making sure the shift mechanism is in DRIVE.