Functional Test - System Road Test Inspection
- Fasten the safety belts and proceed to a safe area.
- Attain a speed of 8 km/h (5 mph).
- Test the safety belts.
- Grasp the shoulder harness and prepare to lean forward.
- Make a maximum brake application without a skid.WARNING: The maximum brake application should be on dry concrete or equivalent hard surface, NEVER on wet pavement or gravel.WARNING: The driver and passenger must be prepared to brace themselves in the event the retractor does not lock.
- The safety belts should lock up with minimum webbing extension.
- If there is a lockup of both shoulder straps, the safety belt assemblies are functioning correctly. Should either or both retractors fail to lock up at the 8 km/h (5 mph) speed, repeat the test at a constant 24 km/h (15 mph) speed. (This test must be carried out with the assistance of a RH front or rear passenger if the RH front or rear safety belts are to be tested.)
- If the retractors do not lock up at the 24 km/h (15 mph) test, return the vehicle for service of malfunctioning safety belts.
NOTE:
If the RH safety belts are to be tested, the assistance of a passenger is required.
WARNING:
The driver and passenger must be prepared to brace themselves if the retractor does not lock.
CAUTION:
Before installing a new safety belt assembly, inspect the mounting area for damage and distortion. If the retractor of a new safety belt assembly has been bolted into a damaged or distorted mounting area, the retractor could be warped and may not function. If this is the case, remove the retractor and return the sheet metal to the original configuration and install another complete safety belt assembly.