Removal and Installation
- Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
- Remove the cowl panel grille. For additional information, refer to FRONT END BODY PANELS .
- Disconnect the windshield wiper motor electrical connector.
- Remove the bolts and the cowl lower panel.
- To install, tighten to 6 Nm (53 lb-in).
- Disconnect the electrical connector from the ignition coil.
- Disconnect the 6 spark plug wires from the ignition coil.
- Remove the 3 bolts and the ignition coil.
- To install, tighten to 7 Nm (62 lb-in).
- To install, reverse the removal procedure.
CAUTION:
It is important to twist the spark plug wire boots, while pulling upward, to avoid possible damage to the spark plug wires.
CAUTION:
Spark plug wires must be connected to the correct ignition coil terminal.