Remote Keyless Entry Transmitter Programming
NOTE:
All RKE transmitters are programmable and must be set at the same time.
NOTE:
Programming of the RKE transmitters can be accomplished using a scan tool or by carrying out the following steps:
- Turn the key from OFF to RUN 8 times within 10 seconds, ending in RUN. The locks then lock and unlock, confirming program mode has been entered.
- Press any button on each RKE transmitter to be programmed. The doors lock and unlock to confirm that each RKE transmitter has been programmed.
- If additional RKE transmitters are to be programmed, repeat Step 2 within 7 seconds. If more than 7 seconds have elapsed, the entire procedure must be repeated.
- To exit program mode, wait at least 7 seconds or turn the ignition key to the OFF position.
- Wait at least 20 seconds after turning the key to the OFF position, or after the last RKE transmitter is programmed, to activate a RKE transmitter for testing and verification.