Transmission Range (TR) Sensor Adjustment
Special Tools
| Illustration | Tool Name | Tool Number |
|---|---|---|
| Alignment Gauge, TR Sensor | 307-351 (T97L-70010-A) |
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
- Loosen the digital transmission range (TR) sensor bolts.
- Using the special tool, align the digital TR sensor slots. The tool is designed to fit snugly.
- Tighten the digital TR sensor bolts and remove the special tool.
- Tighten to 9 Nm (80 lb-in).
- Verify that the vehicle starts in the PARK and NEUTRAL positions and the reverse lamps illuminate in REVERSE.
- If equipped with fire suppression system, repower the system.
WARNING:
Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in FIRE SUPPRESSION SYSTEM
article. Failure to follow the instructions may result in serious personal injury.
NOTE:
Make sure that the manual lever is in the NEUTRAL position.
CAUTION:
Tightening one screw before tightening the other may cause the sensor to bind or become damaged.
WARNING:
If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM
article. Failure to follow these instructions may result in serious personal injury.