Instrument Cluster DTCS

INSTRUMENT CLUSTER DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC	Description	Perform Test
B1202	Fuel Sender Circuit Open	Go to Pinpoint Test B .
B1204	Fuel Sender Circuit Short to Ground	Go to Pinpoint Test B .
B1205	EIC Switch-1 Assembly Circuit Failure	VERIFY that the instrument cluster bezel is aligned correctly and the SELECT/RESET button is not binding. REPAIR as necessary. If the switch is not binding, INSTALL a new instrument cluster. REFER to Instrument Cluster (IC) .
B1317	Battery Voltage High	REFER to CHARGING SYSTEM - GENERAL INFORMATION article.
B1318	Battery Voltage Low	REFER to CHARGING SYSTEM - GENERAL INFORMATION article.
B1319	Driver Door Ajar Circuit Failure	REFER to INTERIOR LIGHTING article.
B1327	Passenger Door Ajar Circuit Failure	REFER to INTERIOR LIGHTING article.
B1342	ECU Is Faulted	NOTE: If other DTCs are present, REPAIR them before installing a new component. CLEAR the DTCs. REPEAT the self-test. If DTC B1342 is retrieved again, INSTALL a new instrument cluster. REFER to Instrument Cluster (IC) .
B1352	Ignition Key-In Circuit Failure	REFER to WARNING DEVICES article.
B1360	Ignition Run/Acc Circuit Open	Go to Pinpoint Test A .
B2143	NVM Memory Failure	INSTALL a new instrument cluster. REFER to Instrument Cluster (IC) .
B2477	Module Configuration Failure	ATTEMPT to configure the instrument cluster again. CLEAR the DTCs. REPEAT the self-test. If DTC B2477 is retrieved again, INSTALL a new instrument cluster. REFER to Instrument Cluster (IC) in this section.
B2658	Wait to Start Warning Indicator Circuit Open	CLEAR the DTCs. REPEAT the self-test. If DTC B2658 is retrieved again, INSTALL a new instrument cluster (IC). REFER to Instrument Cluster (IC) .
B2982	Park Brake Switch Input Circuit Open	Go to Pinpoint Test K .
U0002	High Speed CAN Communication Bus Performance	CLEAR the DTCs. REPEAT the self-test. If DTC U0002 returns, REFER to MODULE COMMUNICATIONS NETWORK article.
U0011	Medium Speed CAN Communication Bus Performance	CLEAR the DTCs. REPEAT the self-test. If DTC U0011 returns, REFER to MODULE COMMUNICATIONS NETWORK article.
U1900	CAN Communication Bus Fault - Receive Error	CLEAR the DTCs. REPEAT the self-test. If DTC U1900 returns, REFER to MODULE COMMUNICATIONS NETWORK article.
U2023	Fault Received From External Node	CLEAR the DTCs. REPEAT the self-test. If DTC U2023 returns, REFER to MODULE COMMUNICATIONS NETWORK article.
U2050	No Application Present	CLEAR the DTCs. REPEAT the self-test. If DTC U2050 returns, REFER to MODULE CONFIGURATION article.
All other DTCs	-	REFER to MULTIFUNCTION ELECTRONIC MODULES article.