Camber Adjustment - Front

Camber Adjustment - Front

NOTE: Front camber is adjusted through the use of the upper strut plate. Rotating the upper strut plate 180 degrees will change the camber +0.5 degrees.

1. Using alignment equipment and the manufacturer's instructions, measure the camber.
2. Remove the 4 strut upper mounting plate nuts.
^ To install, tighten to 30 Nm (22 ft. lbs).
3. Using a suitable jack, raise the vehicle body enough to allow the front strut upper plate mounting studs to clear the frame.

4. NOTE: Rotating the upper strut plate 180 degrees will change the camber +0.5 degrees.

Rotate the upper mounting plate 180 degrees.
5. Recheck the front camber settings.
6. Check and, if necessary, adjust the front toe.