ABS Module Calibration
NOTE:
When installing a new ABS module or hydraulic control unit (HCU), the ABS module must be calibrated. The installation of a new stability control sensor cluster does not require ABS module calibration.
If a DTC is set for any component of the stability control system, the DTC must be cleared before carrying out the calibration procedure. The need to calibrate the ABS module is also indicated by the ABS warning indicator on the instrument cluster module flashing once every 2 seconds. The warning indicator flashes after clearing the DTCs that are associated with the RSC system. If a DTC is retrieved after calibration, refer to the ABS MODULE DTC CHART . Follow the scan tool instructions for the calibration procedure.