April 5, 2026: LEMON Manuals is launched! Read the announcement.

Torca® Clamp

Remove the nut from the Torca® clamp.
Grind the spot weld from the Torca® clamp and remove the clamp.
Clean the uneven surface area and position a new Torca® clamp.

Fig 1: Locating Uneven Surface Area

GF0030135

Courtesy of FORD MOTOR CO.

Make sure the button is fully seated inside the notch.

Fig 2: Making Sure Button Is Fully Seated Inside Notch

GF0032020

Courtesy of FORD MOTOR CO.

NOTE: Do not tighten the clamp until the exhaust system has been aligned.

Tighten the new Torca® clamp.
- Tighten to 47 Nm (35 lb-ft).