LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2007 >> Edge SE, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission External Controls >> General Procedures >> Selector Lever Cable Adjustment
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Selector Lever Cable Adjustment

  1. Disconnect the selector lever cable end from the manual lever.
    2. Fig 1: Locating Selector Lever Cable End
    GF0031989Courtesy of FORD MOTOR CO.
  2. Place the manual lever in DRIVE.
    1. Rotate the manual lever clockwise until it stops.
    2. Rotate the manual lever counterclockwise one detent.
    3. Fig 2: Rotating Manual Lever Clockwise & Counterclockwise
    GF0031966Courtesy of FORD MOTOR CO.
  3. Place the selector lever in DRIVE.
    4. Fig 3: Placing Selector Lever In Drive
    GF0031990Courtesy of FORD MOTOR CO.
  4. Unlock the adjuster by sliding the locking tab over.
    5. Fig 4: Unlocking Adjuster By Sliding Locking Tab Over
    GF0031991Courtesy of FORD MOTOR CO.
  5. Slide the cable end forward or backward to align it with the manual lever.
    6. Fig 5: Sliding Cable End Forward Or Backward To Align It With Manual Lever
    GF0031992Courtesy of FORD MOTOR CO.
  6. With the adjuster locking tab released, connect the selector lever cable end to the manual lever.
    7. Fig 6: Connecting Selector Lever Cable End To Manual Lever
    GF0031969Courtesy of FORD MOTOR CO.
  7. Slide the release tab back to lock the adjuster.
    8. Fig 7: Sliding Release Tab Back To Lock Adjuster
    GF0031970Courtesy of FORD MOTOR CO.
  8. Verify that the vehicle starts in PARK and NEUTRAL only and that the reverse lamps illuminate in REVERSE.
scientia non olet · About LEMON Manuals