Selector Lever Knob: Installation

All vehicles 

1. Route the TC switch electrical connector harness through the selector lever and install the shift knob and 2 new screws. Loosely install both screws before tightening.
   • Tighten to 2 Nm (18 lb-in)
Fig 1: Routing TC Switch Electrical Connector Harness Through Selector Lever
Courtesy of FORD MOTOR CO.
NOTE: Be sure that the shift knob bezel is correctly installed on the shift knob.
2. Install new selector lever knob trim covers.
Fig 2: Installing Selector Lever Knob Trim Covers
Courtesy of FORD MOTOR CO.
NOTE: Center console side trim cover removed for clarity.
3. Connect the transmission control (TC) switch electrical connector.
Fig 3: Locating Transmission Control (TC) Switch Electrical Connector
Courtesy of FORD MOTOR CO.
4. Install the center console trim cover.
Fig 4: Identifying Center Console Trim Cover
Courtesy of FORD MOTOR CO.

MKX 

5. Install the selector lever trim ring.
Fig 5: Locating Selector Lever Trim Ring
Courtesy of FORD MOTOR CO.