LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2007 >> Edge SE, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> Disassembly And Assembly Of Subassemblies >> Stator Support and Gear Assembly >> Disassembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Stator Support and Gear Assembly: Disassembly

  1. Remove and discard the stator support assembly seal.
    2. Fig 1: Locating Stator Support Assembly Seal
    GF0031806Courtesy of FORD MOTOR CO.
  2. Using the special tools, remove and discard the input shaft seal.
    3. Fig 2: Removing Input Shaft Seal Using Special Tools (100-001) & (303-D020)
    GF0031807Courtesy of FORD MOTOR CO.
  3. Remove the drive sprocket thrust washer.
    4. Fig 3: Identifying Drive Sprocket Thrust Washer
    GF0031808Courtesy of FORD MOTOR CO.
  4. Using a suitable tool, remove the stator support-to-torque converter seal.
    5. Fig 4: Locating Stator Support-To-Torque Converter Seal
    GF0031809Courtesy of FORD MOTOR CO.
    NOTE: Note the location of the Torx® head and the hex head bolts for assembly.
  5. Remove the 4 bolts and the stator support feed tube.
    6. Fig 5: Locating Stator Support Feed Tube Bolts
    GF0031810Courtesy of FORD MOTOR CO.
  6. Remove and discard the gasket for the feed tube assembly.
    7. Fig 6: Identifying Gasket On Feed Tube Assembly
    GF0031811Courtesy of FORD MOTOR CO.
  7. Clean and inspect the stator support assembly for damage and replace if necessary.
scientia non olet · About LEMON Manuals