LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2007 >> Edge SEL, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> Disassembly And Assembly Of Subassemblies >> Stator Support and Gear Assembly >> Assembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Stator Support and Gear Assembly: Assembly

  1. Install the special tool on the stator support assembly.
    2. Fig 1: Installing Special Tool (307-579/3) On Stator Support Assembly
    GF0031812Courtesy of FORD MOTOR CO.
  2. Install a new seal on the special tool.
    3. Fig 2: Installing New Seal On Special Tool (307-579/3)
    GF0031813Courtesy of FORD MOTOR CO.
  3. Using the special tool, slide the seal on to the stator support assembly.
    4. Fig 3: Sliding Seal On To Stator Support Assembly Using Special Tools (307-579/2) & (307-579/3)
    GF0031814Courtesy of FORD MOTOR CO.
  4. Remove the special tool from the stator support assembly.
    5. Fig 4: Removing Special Tools (307-579/2) & (307-579/3) From Stator Support Assembly
    GF0031815Courtesy of FORD MOTOR CO.
  5. Install the special tool on the stator support assembly to size the seal.
    6. Fig 5: Installing Special Tool (307-579/1) On Stator Support Assembly To Size The Seal
    GF0031816Courtesy of FORD MOTOR CO.
  6. Install a new gasket on the stator support assembly.
    7. Fig 6: Identifying Gasket On Stator Support Assembly
    GF0031811Courtesy of FORD MOTOR CO.
  7. Install the stator support feed tube assembly.
    1. Position the feed tube assembly in place and install the bolts hand tight.
    2. Tighten the 2 Torx® head bolts.
      • Tighten to 7 Nm (62 lb-in).
    3. Tighten the 2 hex head bolts.
      • Tighten to 12 Nm (9 lb-ft).
    8. Fig 7: Locating Stator Support Feed Tube Assembly & Bolts
    GF0031817Courtesy of FORD MOTOR CO.
  8. Install a new input shaft seal on the special tool.
    9. Fig 8: Installing New Input Shaft Seal On Special Tool (307-585)
    GF0031818Courtesy of FORD MOTOR CO.
  9. Using the special tool, install the input shaft seal.
    10. Fig 9: Installing Input Shaft Seal Using Special Tool (307-585)
    GF0031819Courtesy of FORD MOTOR CO.
  10. Remove the special tool from the stator support assembly.
    11. Fig 10: Removing Special Tool (307-579/1) From Stator Support Assembly
    GF0031820Courtesy of FORD MOTOR CO.
  11. Install the drive sprocket thrust washer.
    12. Fig 11: Identifying Drive Sprocket Thrust Washer
    GF0031808Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals