Intake Manifold Assembly: Assembly
- Install the engine noise shield insulator onto the intake manifold.
- Using a new O-ring seal, install the PCV heater element and the 2 bolts.
- Tighten to 6 Nm (53 lb-in).
- Position the CMCV and install the stud bolt and the 2 bolts.
- Tighten to 10 Nm (89 lb-in).
- Install the CMCV rod locking clips.
- Install new O-ring seals on each of the fuel injectors.
- Assemble the fuel injectors onto the fuel rail and install the locking clips.
- Install the fuel rail and fuel injector assembly onto the intake manifold.
- Install the 4 fuel rail bolts.
- Tighten to 10 Nm (89 lb-in).
- Install the TB, the vibration damper and tighten the bolts in 2 stages.
- Stage 1: Tighten to 9 Nm (80 lb-in).
- Stage 2: Tighten an additional 90 degrees.
NOTE:
Lubricate the new O-ring seal with clean engine oil prior to installation.
NOTE:
Lubricate the new O-ring seal with clean engine oil prior to installation.
NOTE:
Lubricate the TB-to-intake manifold gasket with clean engine coolant prior to installation.