Selector Lever Bezel: Installation

Vehicles equipped with a 6R75 transmission 

1. Connect the electrical harness onto the bezel.
Fig 1: Electrical Harness
Courtesy of FORD MOTOR CO.

All vehicles 

2. Connect the electrical harness onto the selector lever housing.
Fig 2: Electrical Harness
Courtesy of FORD MOTOR CO.
3. Align the brake shift interlock override tab into its guide.
Fig 3: Brake Shift Interlock Override Tab & Guide
Courtesy of FORD MOTOR CO.
4. Install the selector lever bezel onto the selector lever housing.
Fig 4: Selector Lever Bezel Tabs
Courtesy of FORD MOTOR CO.
5. Connect the TC switch electrical connector and install the selector lever knob.
Fig 5: Transmission Control (TC) Switch Electrical Connector
Courtesy of FORD MOTOR CO.
6. Install a new LH selector lever knob screw.
   • Tighten to 2 Nm (18 lb-in).
Fig 6: Left Selector Lever Knob Screw
Courtesy of FORD MOTOR CO.
7. Install a new RH selector lever knob screw.
   • Tighten to 2 Nm (18 lb-in).
Fig 7: Right Selector Lever Knob Screw
Courtesy of FORD MOTOR CO.
NOTE: Wood-trimmed vehicles have a rubber damper not found on other trim levels.
8. Install a new LH selector lever knob cover.
Fig 8: Selector Lever Knob & Left Cover
Courtesy of FORD MOTOR CO.
NOTE: Wood-trimmed vehicles have a rubber damper not found on other trim levels.
9. Install a new RH selector lever knob cover.
Fig 9: Selector Lever Knob & Right Cover
Courtesy of FORD MOTOR CO.
10. Install the console upper trim and the screw.
Fig 10: Console Upper Trim Screw
Courtesy of FORD MOTOR CO.
11. Install the PRNDL trim, console tray and cup holder insert.
Fig 11: PRNDL Trim, Console Tray & Cup Holder Insert
Courtesy of FORD MOTOR CO.
12. Verify brake shift interlock function.