LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2007 >> Focus SES, 2D Hatchback, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> Disassembly And Assembly Of Subassemblies >> Final Drive Carrier and Differential Assembly >> Assembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Final Drive Carrier and Differential Assembly: Assembly

  1. Lubricate the gears and thrust washers with clean automatic transmission fluid.
    2. Fig 1: Identifying Gears And Thrust Washers
    GF0039825Courtesy of FORD MOTOR CO.
  2. Install the different pinion gears and thrust washers.
    1. Install the differential side gears and thrust washers.
    2. Install the differential pinion gears and thrust washers by rotating 90 degrees.
    3. Fig 2: Identifying Differential Pinion Gears And Thrust Washers
    GF0039826Courtesy of FORD MOTOR CO.
    NOTE: Install a new roll pin.
  3. Install the differential pinion shaft.
    1. Install the pinion shaft.
    2. Install the roll pin.
    4. Fig 3: Identifying Differential Pinion Shaft And Roll Pin
    GF0039827Courtesy of FORD MOTOR CO.
    NOTE: LH shown, RH similar.
  4. Using the special tool, install the differential case bearings.
    5. Fig 4: Identifying Special Tool
    GF0039828Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals