Torque Specifications
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Converter housing bolts | 47 | 35 | - |
| Converter housing-to-transaxle case bolts and stud | 22 | 16 | - |
| Electrical connector bracket nuts | 25 | 18 | - |
| Final drive input gear bearing retainer nut pre-torque | 400 | 295 | - |
| Final drive input gear bearing retainer nut rotational torque | 0.4-0.7 | - | 3.5-6.2 |
| Fluid filler tube bolts | 8 | - | 71 |
| Intermediate/overdrive band anchor bolt | 45 | 33 | - |
| Intermediate/overdrive band servo cover bolts | 13 | 10 | - |
| Intermediate shaft retaining bracket bolts | 25 | 18 | - |
| Line pressure tap | 13 | 10 | - |
| Lower suspension arm bolt | 63 | 46 | - |
| Manual control lever bolt | 30 | 22 | - |
| Main control valve body boltsa | - | - | - |
| Main control wire harness ground bolt | 10 | - | 89 |
| Output shaft speed (OSS) sensor bolt | 10 | - | 89 |
| Parking pawl cover bolts | 13 | 10 | - |
| Pump bolts | 10 | - | 89 |
| Pump case bolts | 30 | 22 | - |
| Rear engine mounting bracket | 80 | 59 | - |
| Rear engine mounting (4 nuts) | 48 | 35 | - |
| Rear engine mounting center nut | 150 | 111 | - |
| RH engine support insulator bolts | 48 | 35 | - |
| RH front drive halfshaft center bearing cap nuts | 25 | 18 | - |
| Suspension strut nuts | 30 | 22 | - |
| Shift cable bracket bolts | 20 | 15 | - |
| Shift cable clip bolt | 47 | 35 | - |
| Shifter assembly bolt | 13 | 10 | - |
| Solenoid body boltsa | - | - | - |
| Stabilizer bar nuts | 55 | 41 | - |
| Starter motor bolts | 35 | 26 | - |
| Transaxle end cover bolts | 22 | 16 | - |
| Transmission fluid cooler line fittings | 33 | 24 | - |
| Transmission fluid pan bolts | 10 | - | 89 |
| Transmission range (TR) sensor bolts | 10 | - | 89 |
| Turbine shaft speed (TSS) sensor bolt | 10 | - | 89 |
| Torque converter-to-engine flexplate nuts | 40 | 30 | - |
| Tie-rod end nut | 40 | 30 | - |
a Refer to the appropriate procedure.