LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2007 >> Focus ST >> Repair and Diagnosis >> Brakes >> Traction Control >> Vehicle Dynamic Systems >> Diagnostic Tests >> Anti-Lock Control >> Inspection and Verification >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection and Verification: Notes

NOTE: If a new ABS module is installed, it must be configured. REFER to MODULE CONFIGURATION article.
  1. Verify the customer concern.
  2. Visually inspect for obvious signs of mechanical or electrical damage.
    VISUAL INSPECTION CHART

    Mechanical Electrical
    • Wheel speed sensor
    • Hydraulic control unit (HCU)
    • Incorrectly inflated tires
    • Ford specified steering components, suspension components and tire size
    • Wheel speed sensor ring
    • Battery junction box (BJB) fuse(s):
      • 5 (30A)
      • 13 (20A)
      • 29 (10A)
    • Circuitry
    • ABS module
    • Traction control switch (if equipped)
    • Wheel speed sensor
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
    4. NOTE: Make sure to use the latest scan tool software release.
  4. If the cause is not visually evident, connect the scan tool to the data link connector (DLC).
    5. NOTE: The vehicle communication module (VCM) LED prove out confirms power and ground from the DLC are provided to the VCM.
  5. If the scan tool does not communicate with the VCM:
    • check the VCM connection to the vehicle.
    • check the scan tool connection to the VCM.
    • refer to MODULE COMMUNICATIONS NETWORK article, No power to the scan tool, to diagnose no communication with the scan tool.
  6. If the scan tool does not communicate with the vehicle:
    • verify the ignition key is in the ON position.
    • verify the scan tool operation with a known good vehicle.
    • refer to MODULE COMMUNICATIONS NETWORK article to diagnose no response from the powertrain control module (PCM).
  7. Carry out the network test.
    • If the scan tool responds with no communication for one or more modules, refer to MODULE COMMUNICATIONS NETWORK article.
    • If the network test passes, retrieve and record continuous memory diagnostic trouble codes (DTCs).
  8. Clear the continuous DTCs and carry out the self-test diagnostics for the anti-lock brake system (ABS) module.
  9. If the DTCs retrieved are related to the concern, go to Anti-Lock Brake System (ABS) Module Diagnostic Trouble Code (DTC) Index . For all other DTCs, refer to MULTIFUNCTION ELECTRONIC MODULES article.
  10. If no DTCs related to the concern are retrieved, go to Symptom Chart .
scientia non olet · About LEMON Manuals