LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2007 >> Freestar SEL >> Repair and Diagnosis >> Engine Performance >> Engine Ignition System >> Removal And Installation >> Spark Plugs >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Spark Plugs: Installation

  1. Adjust the spark plug gap as necessary.
    2. Fig 1: Spark Plug Gap (With Specifications)
    GF0033248Courtesy of FORD MOTOR CO.
    CAUTION: Only use hand tools when removing or installing the spark plugs, or damage can occur to the cylinder head or spark plug.
  2. Install the 6 spark plugs.
    • Tighten to 15 Nm (11 lb-ft).
  3. Apply dielectric grease to the inside of the spark plug wire boots before attaching to the spark plugs.
    4. CAUTION: Spark plug wires must be connected to the correct spark plug.
    CAUTION: Make sure the spark plug boots are positioned so the spark plug wires do not contact the exhaust manifold.
  4. Connect the 6 spark plug wires to the spark plugs.
  5. Install the cowl lower panel and the bolts.
    • Tighten to 6 Nm (53 lb-in).
  6. Connect the windshield wiper motor electrical connector.
    7. Fig 2: Locating Windshield Wiper Motor Electrical Connector
    G04004018Courtesy of FORD MOTOR CO.
  7. Install the cowl panel grille. For additional information, refer to FRONT END BODY PANELS article.
    8. Fig 3: Locating Cowl Top Panel Bolts
    G04004019Courtesy of FORD MOTOR CO.
  8. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
scientia non olet · About LEMON Manuals