LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2007 >> Taurus SE >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine >> In-Vehicle Servicing >> Connecting Rod Bearings >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Connecting Rod Bearings: Installation

    CAUTION: The connecting rod bearings are precision fit. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION article for checking clearances or bearing selection.
    CAUTION: The connecting rod bearings must be lubricated with clean engine oil prior to installation or damage to the connecting rod bearing may occur.
  1. Install the connecting rod bearings.
  2. Install the connecting rod bearing cap and 2 nuts.
    • Tighten to 35 Nm (26 lb-ft).
  3. Repeat the procedure until all the connecting rod bearings are replaced.
  4. If removed, install the oil pump. For additional information, refer to Engine Lubrication Components - Exploded View, Oil Pan, Oil Pan Baffle and Oil Pump  and Oil Pump .
  5. Install the oil pan. For additional information, refer to Engine Lubrication Components - Exploded View, Oil Pan, Oil Pan Baffle and Oil Pump  and Oil Pan .
scientia non olet · About LEMON Manuals