LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2007 >> Taurus SE >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> In-Vehicle Servicing >> Digital Transmission Range (TR) Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Digital Transmission Range (TR) Sensor: Installation

  1. Verify that the shift selector lever is in NEUTRAL.
  2. Install the digital TR sensor and loosely install the bolts.
    3. Fig 1: Locating Digital TR Sensor Bolts
    GF0020154Courtesy of FORD MOTOR CO.
  3. Using the special tool, align the digital TR sensor and tighten the bolts.
    • Tighten to 11 Nm (8 lb-ft).
    4. Fig 2: Aligning Digital TR Sensor Using Special Tool (307-351)
    GF0020155Courtesy of FORD MOTOR CO.
  4. Connect the connector.
    5. Fig 3: Identifying Digital Transmission Range (TR) Sensor Electrical Connector
    GF0020152Courtesy of FORD MOTOR CO.
  5. Install the shift cable and manual control lever nut.
    1. Install the shift cable into the bracket.
    2. Install the manual control lever nut.
      • Tighten to 13 Nm (10 lb-ft).
    6. Fig 4: Identifying Manual Control Lever Nut
    GF0020156Courtesy of FORD MOTOR CO.
  6. Install the air filter assembly.
    7. Fig 5: Locating Air Filter Assembly
    GF0020151Courtesy of FORD MOTOR CO.
  7. Install the engine air cleaner.
    8. Fig 6: Locating Engine Air Cleaner Lid
    GF0020150Courtesy of FORD MOTOR CO.
  8. Reconnect the mass air flow (MAF) sensor and the breather tubes.
    9. Fig 7: Locating Mass Air Flow (MAF) Sensor And Breather Tubes
    GF0019965Courtesy of FORD MOTOR CO.
  9. Check for correct vehicle operation.
scientia non olet · About LEMON Manuals