LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2007 >> Taurus SEL >> Repair and Diagnosis >> Steering >> Power Steering >> Power Steering System >> Removal And Installation >> Power Steering Pump >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Power Steering Pump: Installation

  1. Position the power steering pump and install the 3 power steering pump bolts.
    • Tighten to 47 Nm (35 lb-ft).
    2. NOTE: The pulley must be installed within 0.25 mm (0.010 in) flush with the power steering pump shaft.
  2. Using the special tool, install the power steering pump pulley.
    3. Fig 1: Special Tool On Power Steering Pump Pulley
    GF0020618Courtesy of FORD MOTOR CO.
  3. Connect the power steering return hose to the power steering pump.
  4. Connect the electrical connector.
    5. NOTE: Whenever a line fitting with Teflon® O-ring seal is disconnected, a new Teflon® O-ring seal must be installed.
  5. Using the special tool, install a new Teflon® O-ring seal on the power steering pressure line fitting.
    6. Fig 2: Installing Teflon(R) O-Ring Seal On Power Steering Pressure Line Fitting
    GF0020619Courtesy of FORD MOTOR CO.
  6. Connect the PSP line to the power steering pump.
    • Tighten to 37 Nm (27 lb-ft).
  7. Rotate the tensioner counterclockwise and install the belt onto the power steering pump pulley.
  8. Fill and leak check the system. For additional information, refer to STEERING SYSTEM - GENERAL INFORMATION article.
scientia non olet · About LEMON Manuals