LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2007 >> Taurus SEL >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> In-Vehicle Servicing >> Output Shaft Speed (OSS) Sensor >> Removal And Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal And Installation

  1. Disconnect the output shaft speed (OSS) sensor connector.
    2. Fig 1: Output Speed Shaft Speed (OSS) Sensor Connector
    GF0020131Courtesy of FORD MOTOR CO.
    NOTE: The OSS sensor is located under the RH exhaust manifold.
  2. Remove the OSS sensor cover.
    1. Remove the connector.
    2. Remove the bolt.
      • To install, tighten to 11 Nm (8 lb-ft).
    3. Remove the cover.
    3. Fig 2: Identifying OSS Sensor Cover
    GF0020132Courtesy of FORD MOTOR CO.
  3. Remove the OSS sensor.
    4. Fig 3: Output Speed Shaft Speed (OSS) Sensor
    GF0020133Courtesy of FORD MOTOR CO.
    NOTE: Lubricate the OSS O-ring before installing the sensor.
  4. To install, reverse the removal procedure.
    5. Fig 4: Locating OSS O-Ring
    GF0020134Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals