Vehicle Dynamic Systems DTCS
ABS MODULE DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Source | Perform Test |
|---|---|---|---|
| B1342 | Electronic Control Unit (ECU) is Defective | ABS Module | INSTALL a new ABS module. REFER to Anti-Lock Brake System (ABS) Module . |
| B1484 | Brake Pedal Input Open Circuit | ABS Module | Go to Pinpoint Test D . |
| B1596 | Service Continuous Codes | ABS Module |
NOTE:
If other DTCs are present, REPAIR them before installing a new component. TURN the ignition switch to the OFF position and wait at least 30 seconds. TURN the ignition switch to the ON position. REPEAT the ABS self-test. If any DTCs are retrieved, REFER to ABS MODULE DIAGNOSTIC TROUBLE CODE INDEX. If no DTCs are retrieved, CARRY OUT a drive test above 15 km/h (9 mph), then REFER to the Symptom Chart
. |
| B1676 | Battery Voltage Out of Range | ABS Module | Go to Pinpoint Test E . |
| C1145 | Speed Wheel Sensor RF Input Circuit Failure | ABS Module | Go to Pinpoint Test B . |
| C1155 | Speed Wheel Sensor LF Input Circuit Failure | ABS Module | Go to Pinpoint Test B . |
| C1165 | Speed Wheel Sensor RR Input Circuit Failure | ABS Module | Go to Pinpoint Test B . |
| C1175 | Speed Wheel Sensor LR Input Circuit Failure | ABS Module | Go to Pinpoint Test B . |
| C1222 | Speed Wheel Mismatch | ABS Module | MAKE SURE the tires are the same size and correctly inflated. INSPECT the wheel speed sensor rings. CLEAR the DTC. TEST drive the vehicle. REPEAT the self-test. |
| C1266 | ABS Valve Power Relay Circuit Failure | ABS Module | Go to Pinpoint Test H . |
| C1296 | Wheel Speed LF Signal Fault | ABS Module | Go to Pinpoint Test C . |
| C1297 | Wheel Speed RF Signal Fault | ABS Module | Go to Pinpoint Test C . |
| C1298 | Wheel Speed RR Signal Fault | ABS Module | Go to Pinpoint Test C . |
| C1299 | Wheel Speed LR Signal Fault | ABS Module | Go to Pinpoint Test C . |
| C1300 | ABS Hydraulic Pump Motor Circuit Failure | ABS Module | Go to Pinpoint Test A . |
| C1805 | Mismatched PCM and ABS Modules Do Not Match | ABS Module | CHECK the part numbers. INSTALL the correct module. |
| C2775 | TC ON/OFF Switch Stuck Failure | ABS Module | Go to Pinpoint Test G . |
| U0073 | Control Module Communication Bus Off | CAN Bus | REFER to MODULE COMMUNICATIONS NETWORK article. |
| U1900 | CAN Communication Bus Fault - Receive Error | CAN Bus | REFER to MODULE COMMUNICATIONS NETWORK article. |
| U2023 | Fault Received From External Node | CAN Bus | REFER to MODULE COMMUNICATIONS NETWORK article. |