Removal And Installation
NOTE:
Electronic modules are sensitive to electrical charges. The anti-lock brake system (ABS) module can be damaged if exposed to these charges.
NOTE:
Do not allow any brake fluid or foreign material to enter the mating side of the anti-lock brake system (ABS) module or damage to the solenoids can occur.
- Remove the hydraulic control unit (HCU). For additional information, refer to Hydraulic Control Unit (HCU) .
- Remove the 4 ABS module screws and the ABS module.
- To install, tighten to 5 Nm (44 lb-in).
- To install, reverse the removal procedure.
NOTE:
Visually inspect the ABS module terminals for damage before installation.