Safety Belt System: Notes

WARNING: After any crash, all of the following safety belt assemblies and attaching hardware must be inspected by an authorized dealer to verify correct function:

Retractors
Buckles
Belt tension sensor (BTS) (if equipped)
Front safety belt buckle support assemblies (slide bar) (if equipped)
Safety belt shoulder belt height adjusters (if equipped)
Child safety seat tether bracket assemblies
Automatic locking retractor (ALR) feature for child safety seats (passenger seating positions only)

If any safety belt assembly is damaged, does not operate correctly or does not pass all of the Functional Tests in the COMPONENT TEST portion of this service information , a new safety belt assembly must be installed. If any safety belt assembly attaching areas are damaged or distorted, the sheet metal must be restored to its original structural integrity and new safety belt assembly and attaching hardware must be installed. Failure to install new safety belt assemblies and attaching hardware may increase the risk of serious personal injury or death in a crash.

After any crash that results in deployment of the driver and/or front outboard passenger safety belt pretensioners, new driver and/or front outboard passenger safety belt systems (including retractors, buckles and height adjusters) must be installed. Failure to install new safety belt systems increases the risk of serious personal injury or death in a crash.

When replacing any active occupant restraint components, use only the replacement parts specified in the Ford Customer Service Division Master Parts Catalog.

The active restraint system consists of the following:

Front row safety belt buckles, attached to the inboard side of the seats
Front row safety belt retractors and pretensioners, located behind the lower B-pillar trim panels
Second row outboard safety belt retractors, located behind the rear quarter trim panels
Second row 60/40 seat center safety belt retractor and LH safety belt buckle assembly is integrated into the 60 percent seat back
Second row dual safety belt buckle assembly for the 60/40 seat attached to the 60/40 seat
Second row lower anchors and tethers for children (LATCH) at all outboard rear seating positions, welded to the seat backrest frame
Child safety seat tether anchors attached to the back of the rear seat