Throttle Body: Installation
- Using a new O-ring seal, position the TB and vibration damper and tighten the 4 bolts in 2 stages.
- Stage 1: Tighten to 9 Nm (80 lb-in).
- Stage 2: Tighten an additional 90 degrees.
- Connect the TP sensor electrical connector.
- Connect the electronic throttle control electrical connector.
- Lubricate the air cleaner outlet pipe-to-TB adapter seal with clean engine coolant prior to installation.
Courtesy of FORD MOTOR CO.
- Position the air cleaner outlet pipe-to-TB adapter and install the 4 bolts.
- Tighten to 10 Nm (89 lb-in).
- Connect the generator wiring harness retainer to the air cleaner outlet tube-to-TB adapter.
Courtesy of FORD MOTOR CO.
- Position the crankcase vent tube and connect the quick connect couplings. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION
article.
- Install the air cleaner outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING
article.
- Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES
article.