Spring Lock Couplings: Connect

Inspect and clean both spring lock coupling ends. Install new O-ring seals and garter springs, if necessary.

Fig 1: Locating O-Rings & Garter Springs

Courtesy of FORD MOTOR CO.

NOTE: Make sure the fuel tube clicks into place when installing the tube. To make sure that the fuel tube is fully seated, pull on the tube.

NOTE: Apply clean engine oil to the O-ring seals.

Fit the male end into the female end and push until the garter spring snaps over the flared end of the female end.

Fig 2: Connecting Coupling Ends

Courtesy of FORD MOTOR CO.

Fig 3: Checking Coupling Connection

Courtesy of FORD MOTOR CO.

Fig 4: Fuel Tube Safety Clip

Courtesy of FORD MOTOR CO.

Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.