Selector Lever Bezel: Removal

All vehicles 

NOTE: 6R75 transmission selector lever shown, 6HP26 similar.
1. Remove the PRNDL trim, console tray and cup holder insert.
Fig 1: PRNDL Trim, Console Tray & Cup Holder Insert
Courtesy of FORD MOTOR CO.
2. Remove the screw and the console upper trim.
Fig 2: Console Upper Trim Screw
Courtesy of FORD MOTOR CO.
3. Remove and discard the RH selector lever knob cover.
   1. Start at the bottom front only.
   2. Move towards the top front and remove the cover.
Fig 3: Selector Lever & Right Knob Cover
Courtesy of FORD MOTOR CO.
4. Remove and discard the LH selector lever knob cover.
   1. Start at the bottom front only.
   2. Move towards the top front and remove the cover.
Fig 4: Selector Lever & Left Knob Cover
Courtesy of FORD MOTOR CO.
5. Remove and discard the RH selector lever knob screw.
Fig 5: Right Selector Lever Knob Screw
Courtesy of FORD MOTOR CO.
NOTE: Verify the LH and RH knob body towers are present and not damaged.
6. Remove and discard the LH selector lever knob screw.
Fig 6: Left Selector Lever Knob Screw
Courtesy of FORD MOTOR CO.
7. Disconnect the transmission control (TC) switch electrical connector and remove the selector lever knob.
Fig 7: Transmission Control (TC) Switch Electrical Connector
Courtesy of FORD MOTOR CO.
8. Lift the tabs on the selector lever bezel and lift the bezel for access to the electrical harness.
Fig 8: Selector Lever Bezel Tabs
Courtesy of FORD MOTOR CO.
9. Disconnect the electrical harness from the selector lever housing.
Fig 9: Electrical Harness
Courtesy of FORD MOTOR CO.

Vehicles equipped with a 6R75 transmission 

10. Disconnect the electrical harness from the bezel.
Fig 10: Electrical Harness
Courtesy of FORD MOTOR CO.