Removal And Installation
- Remove the exhaust flexible pipe. For additional information, refer to EXHAUST SYSTEM article.
- Position a floor jack and the special tool under the oil pan.
- Remove the engine coolant degas bottle. For additional information, refer to ENGINE COOLING article.
- Remove the nut, bolt and engine mount brace.
- To install, tighten to 20 Nm (15 lb-ft).
- Remove the 4 engine mount nuts.
- To install, tighten to 63 Nm (46 lb-ft).
- Remove the 4 engine mount studs.
- To install, tighten to 18 Nm (13 lb-ft).
- Remove the 3 bolts and the engine mount.
- To install, tighten to 90 Nm (66 lb-ft).
- To install, reverse the removal procedure.
NOTE:
The special tool must be carefully aligned to the mounting bosses on the oil pan. Failure to follow these instructions may result in damage to the oil pan.