LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2008 >> Taurus SEL, FWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Removal And Installation >> Stability Control Sensor Cluster >> Removal And Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal And Installation

NOTE: When installing a new stability control sensor cluster, the ABS module must be calibrated. Follow the scan tool directions for the calibration procedures.
  1. Remove the front floor console. For additional information refer to INSTRUMENT PANEL AND CONSOLE article.
  2. Disconnect the stability control sensor cluster electrical connector.
  3. Remove the stability control sensor cluster electrical harness retainers and position aside.
  4. Remove the 2 stability control sensor cluster bracket bolts and the stability control sensor cluster.
    • To install, tighten to 12 Nm (106 lb-in).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals