Programming the Auto-lock Feature Using the Door Lock Control Switch
NOTE:
The auto-lock feature can be activated or deactivated independently of the auto-unlock feature.
NOTE:
The auto-lock feature of the Smart Junction Box (SJB) can also be configured ON or OFF with the scan tool. For additional information on module configuration, refer to MODULE CONFIGURATION
article.
NOTE:
When programming the auto-lock feature using the door lock control switch method the following steps must be carried out within 30 seconds or the procedure will need to be repeated. If the procedure needs to be repeated, wait 30 seconds between programming sessions.
- Turn the ignition key from the OFF to the ON position.
- Press the unlock button on the door lock control switch 3 times.
- Turn the ignition key from the ON to the OFF position.
- Press the unlock button on the door lock control switch 3 times.
- Turn the ignition key to the ON position. The horn chirps once to indicate that programming mode is entered.
- To enable/disable the auto-lock feature, press the unlock button on the door lock control switch, then the lock button. The horn chirps once if the auto-locks are disabled or twice (one short chirp followed by a honk) if the auto-locks are enabled.
- Turn the ignition key to the OFF position. The horn chirps once to signal that the programming is complete.
NOTE:
Prior to beginning, make sure the ignition key is in the OFF position and all vehicle doors are closed.